Using esp32, Arduino IDE 1.8.9 on OSX.
My code is interspersed with
Serial.println() writes to the serial monitor of various status messages.
As far as I can tell, if a
println is not fully written out to the serial monitor before another
println is sent, then the first
println does not finish displaying properly, and appears to garbled.
I'm using baud rate 115200.
I'm guessing that there's no flow control between the serial monitor and the computer.
It's strange though because I've been doing quite a bit of Arduino IDE programming for a while now but I don't ever recall this being an issue.
Does anyone have any idea of what might be going on, and how I can ensure that messages are fully displayed on the serial monitor?