I want to use RX(0) and TX(1) Pins to make Arduino as an RS485 slave. To do this I am using MAX485 IC (Breakout board) https://datasheets.maximintegrated.com/en/ds/MAX1487-MAX491.pdf

The problem here is that I don't have any other pins remaining to interface with the module in order to pull the DE/RE pin HIGH/LOW.

Can anyone suggest a way to do this without using one additional pin?



Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Browse other questions tagged or ask your own question.