0

I use Vector network to send CAN messages to MCP2515 through CAN HIGH and CAN LOW lines. I connect MCP2515 with Arduino Due through SPI protocol.

Connections are good. But I receive "not acknowledge error" in the CANoe software.

I can't send CAN message to the MCP2515 itself.

  • please provide schematic or connection diagram .... also provide the minimum code that exhibits the described failure – jsotola Jan 8 at 18:30

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.