0

I had used Arduino Uno & RFID but now i want to run same code in Esp8266MOD. i have installed all the drivers and everything else to run esp8266 in Arduino IDE but i dont know how to connect rfid in esp8266. Can someone please compare which arduino pin & esp8266 pin are similar

 * Typical pin layout used:
 * ------------------------------------------------------
 *             MFRC522      Arduino       NodeMCU
 *             Reader/PCD   Uno/101       ESP8266MOD
 * Signal      Pin          Pin           Pin       
 * ------------------------------------------------------
 * RST/Reset   RST          9             ?
 * SPI SS      SDA(SS)      10            ?
 * SPI MOSI    MOSI         11 / ICSP-4   ?
 * SPI MISO    MISO         12 / ICSP-1   ?
 * SPI SCK     SCK          13 / ICSP-3   ?
0

table filled

 * Typical pin layout used:
 * ------------------------------------------------------
 *             MFRC522      Arduino       NodeMCU
 *             Reader/PCD   Uno/101       ESP8266MOD
 * Signal      Pin          Pin           Pin       
 * ------------------------------------------------------
 * RST/Reset   RST          9             any, recommended 5
 * SPI SS      SDA(SS)      10            any, recommended 4, possible 15
 * SPI MOSI    MOSI         11 / ICSP-4   13
 * SPI MISO    MISO         12 / ICSP-1   12
 * SPI SCK     SCK          13 / ICSP-3   14

io 15 is SS if esp8266 is slave. but this pin must be LOW at boot. you can use it as SS if SS pin of reader doesn't pull-up.

io 4 and io 5 are untroubled pins.

io 0 and io 2 are with io 15 boot configuration pins and can be used only if they don't change the required boot state.

io 1 and io 3 are Serial interface

io 16 is RTC pin and is used for wake up from deep slepp

warning: does the reader work with 3.3 V?

  • @ashis, did it help? – Juraj Dec 23 '18 at 15:56

Your Answer

By clicking "Post Your Answer", you acknowledge that you have read our updated terms of service, privacy policy and cookie policy, and that your continued use of the website is subject to these policies.

Not the answer you're looking for? Browse other questions tagged or ask your own question.