This question already has an answer here:
I know there's quite a few threads with similar answers already, but I hope you won't mind me asking anyways. One thread has what looks like a good solution but it's old and thought it may be better to ask fresh.
I have ten 12v rgb strips with 4 wires each, a 12v power supply and 30 mosfets. I want to control them individually with an Uno.
I'd like to make a wave effect where the strips increase and decrease in brightness at separate times. It's fine if they are all the same color during a wave. Then a wave of a different color.
(1) I'm thinking of trying the approach in this thread where AMADANON suggests using 3 pins for the color and then each strip gets its own common pin, 13 pins in my case. If I go this route, will I be able to set a color for all strips and a brightness for individual strips? This would let me make the wave effect I'd like.
(2) Alternately I'm thinking of upgrading to a Mega with 54 pins. I assume I could then control each strip individually using 3x10 = 30 pins?
(3) I've read lots of advice on chips to control the strips, but I'm a newbie and would like to keep it as simple as possible (plus delivery to my country takes 3 weeks or more, and I'd like to get started now)
Thanks for any advice!
EDIT: (I replied to answers in comments, and I now see I should just instead edit this question. Thanks for your patience with a newbie!)
The mosfets are N-Channel MOSFET 60V 30A.
The led strips are rgb non-addressable with 4 wires, wired on both ends so they can be easily daisy-chained. But in my project the strips are snaking around some tracks and connected them in serial poses a problem. I'd prefer to wire each from only one end.
I think I'll try Gerben's and Andrew's advice about a chip and check out PCA9685 chip module as per Andrew's suggestion. Sounds inexpensive!
chrisl's suggestion for using WS2811 chips sounds easy too and maybe less wiring. In the same vein was an idea from this thread from gre_gor:
... which talks about chainable STM32 rgb chips, only about 2 bucks on ebay, no mosfets, and pretty efficient.
Thanks for all the advice guys! I'm finishing the box and strips placement now and waiting for my Arduino to arrive which should be any day. This is my first venture into this domain (though I've done plenty of coding and have some experience with electronics).