After having successfully tested my GPS module with my Arduino UNO, I'm looking to do so with the Discovery Board. The connections seem a little puzzling, as in I can't understand if I need male/female connectors or there's a workaround. Has anyone done this before?

Thanks a lot.

  • Do you have an STM32F401 Discovery in front of you? – Majenko Jul 7 '18 at 22:57
  • @Majenko: Yes, I do. – db18 Jul 7 '18 at 23:11
  • Does it have male or female pins for the UART? – Majenko Jul 7 '18 at 23:21
  • @Majenko: It has all male pins. – db18 Jul 7 '18 at 23:31
  • 1
    So get some female ones then? The only hack would be to give the whole board gender reassignment surgery. – Majenko Jul 7 '18 at 23:42

Your Answer

By clicking "Post Your Answer", you acknowledge that you have read our updated terms of service, privacy policy and cookie policy, and that your continued use of the website is subject to these policies.

Browse other questions tagged or ask your own question.