Today I did some tinkering with an ESP8266, trying out OTA and writing a webserver. To find an error, I reduced the sketch to just the following lines:

#include <ESP8266WebServer.h>

ESP8266WebServer server(80);

void setup() {
  server.on("/", []() {
    Serial.println("Sending response...");
    server.send(200, "text/plain", "Hi there!");

void loop() {

Notice that there is no code to connect to a Wifi network. However, the chip still connects to my local, WPA2-secured, network on every boot. I can ping the chip, my browser can get the "Hi there!" message via http, the Serial message gets printed.

How is this possible? Does the ESP8266 somehow retain the Wifi information, maybe because of some old OTA data that was not completely overwritten?

I'm using platformio. Here's my entire platformio.ini:

platform = espressif8266
board = d1_mini
framework = arduino

I posted the compile and upload log here: https://pastebin.com/BtGrFZiu

1 Answer 1


Yes, normally the last WiFi credentials will be saved in flash and the ESP8266 loads this data on bootup and reconnect to the last known WiFi. See https://github.com/esp8266/Arduino/issues/2843#issuecomment-334250100:

the SDK stores some info, including the wifi credentials, in a sector of the flash.

That sector is kept between flashings to allow for a quick startup after update. On boot, before your sketch is executed, the SDK will retrieve the wifi credentials and attempt a quick connection.

This behaviour can be controlled by using the function WiFi.setAutoConnect(autoConnect) as documented in https://github.com/esp8266/Arduino/blob/master/doc/esp8266wifi/station-class.rst#setautoconnect. This in turn calls the Espressif SDK function wifi_station_set_auto_connect (API reference)

enter image description here

In short: This is normal behaviour. If you want to make sure that your ESP8266 does not connect to any WiFi unless you tell it do it explicitly, call WiFi.setAutoConnect(autoConnect) at the beginning.

Edit: From within the firmware code, you can use system_restore. The documentation says that it would reset WiFi related data. This should destroy previous settings. The function can be included from https://github.com/esp8266/Arduino/blob/master/tools/sdk/include/user_interface.h within Arduino-ESP8266. I have not tried this myself nor can I say that it actually erases security-critical information from flash though.


Or, as you also have found out, hard-erasing the entire flash will purge the WiFi data with absolute certainty. This can be achieved by using esptool.py with the erase_flash option, e.g. python esptool.py -p COM6 erase_flash. Then you can flash the new firmware which will not use previous WiFi settings (but will probably open up the default access point again).

Then there's also ESP.eraseConfig which erases only the relevant flash sectors.

  • Thank you. Is there a way to erase credentials that were previously set from the flash? EDIT: Found that it's possible with esptool: esp8266.com/viewtopic.php?f=32&t=8204
    – Geier
    Commented Apr 21, 2018 at 23:29
  • 1
    @Geier updated. Commented Apr 21, 2018 at 23:32
  • 1
    WiFi.disconnect() removes the remembered credentials too
    – Juraj
    Commented Apr 22, 2018 at 4:48

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.