0

i am using 16x2 LCD with arduino nano for my project.

when i connect arduino nano with usb power supply from pc or any mobile changer adapter then all the character on LCD is visible properly. But when i connect it with 5V regulated power to arduino nano than character on LCD is not visible properly (characters are visible and project is running fine but pixel which needs to be hidden are also little darker so it characters aren’t visible properly)

i have connected Vee pin of LCD with ground for maximum brightness.

Improve this question

1 Answer 1

Reset to default
2

Disconnect Vee from GND and wire it up properly with a potentiometer. It doesn't set the brightness - it sets the bias point for displaying the different pixels in the matrix.

Improve this answer
2
  • then how it is working fine when i connect USB as power supply.
    – Nishant Kathiriya
    Commented Apr 2, 2018 at 3:58
  • Different voltages.
    – Majenko
    Commented Apr 2, 2018 at 8:07

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.