Before you ask - I've checked that the LEDs worked before putting them in my circuit. They all work.
I've connected 4 LEDs, shown in the arrangement below, up to my Adruino Lilypad. Pin 9 was used as the + 5V, the "- pin" was used as ground. In the schematic below, the "1" represents pin 9.
When I start my sketch, I set pin 9 to high to check that all the LEDs are working. (this is a PWM pin so I write,
analogWrite(9, 255);). At this point, only D5 lights up. If I connect up the two wires connecting R9-D6 and R10-D7, then both D5 and D8 light up... but never D7 or D6?
Doing some basic circuit calcs, the total resistance of the circuit is 100 Ohms (1 / (1 / (100 + 100)) + (1 / (100 + 100))). I'm powering from the usb connection to the computer so power source should be 5 V. Total current draw should therefore be 50 mA? Is that too much? If so, why does only D5 - or D5 and D8 when adjusting the circuit - light up?