0

I followed this guide and evertything works until I'm at chapter Configuring the onboard WiFi.

I can see the arduino as an AP.

Arduino Yun Acces point

And I can connect with it. However when entering the IP adress 192.168.240.1 or arduino.local it does not give me the login page. When using the IP adress I get: the site is not accessable screen. Using arduino.local gives me a page that loads forever for a long time before giving me the exact same result.

Page not loading

I have looked on different forums for a solution. This one said that I should download bonjour and bonjour browser because they use the same port (port 5353). After installing the bonjour browser I should be seeing a connection called .arduino._tcp but I don't see that. In fact I often can't see any connection what so ever.

Bonjour browser 1

and sometimes I can see a few connections but none of those are the arduino.

Bonjour browser 2

I have tried to ping with the arduino on the adress 192.168.240.1 but all I got was a time out.

Pinging 192.168.240.1 with 32 bytes of data:
Request timed out.

Edit : I managed to get the bonjour browser to work all the time, by installing itunes. It also shows the arduino.

enter image description here

  • Have you confirmed that your computer has been given a correct IP address on the right subnet through DHCP? – Majenko Dec 17 '17 at 12:42
  • Yes i have checked that. also i just tried to do it on another computer and it seems to work with that computer. – RubenDefour Dec 17 '17 at 12:48
  • So this is a problem with your computer then, not the Yun. I suggest disabling all firewalls and antivirus products and trying again. – Majenko Dec 17 '17 at 12:49
  • Please add a screenshot of WI-FI connection properties. You must be connected to the Arduino-Yun network and not WiFi-2.4-2348_EXT. – AltAir Dec 17 '17 at 15:07
  • @AltAir i replaced the screenshot – RubenDefour Dec 18 '17 at 10:40
1

You have to find IP address of your Yùn on your local network. What I do in this case: - look on the Home router if you can see your Yùn and it's ip, or, - there is a sketch in Arduino Ide / exemple / bridge / wifi status which can help you to get ip, or - open the Arduino Ide software, upload serialTerminal sketch and open serial monitor. It allows you to access the Linux part of the Yùn and type 'ifconfig' to get the IP from the Yùn.

| improve this answer | |
  • Well as you can see on the last screenshot I made the ip is 192.168.240.1 – RubenDefour Dec 19 '17 at 18:40

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.