0

I try move my projects from atmega to ESP8266-07 modules. I connect ESP8266-07 to FT232:

(ESP) RX -------- TX (FT232)
(ESP) TX -------- RX (FT232)
(ESP) GND ------- GND (FT232)
(ESP) VCC ------- VCC 3.3V (FT232)
(ESP) EN -------- VCC 3.3V (FT232)
(ESP) GPIO0 ----- GND (FT232)
(ESP) GPIO15 ---- GND (FT232)

I can upload sketch and it's work. BUT...

... WHEN I restart ESP (software reset or hardware reset - unplug power) program no starting. I try change connections after upload like:

Try 1:
(ESP) RX -------- TX (FT232)
(ESP) TX -------- RX (FT232)
(ESP) GND ------- GND (FT232)
(ESP) VCC ------- VCC 3.3V (FT232)
(ESP) EN -------- VCC 3.3V (FT232)

Try 2:
(ESP) RX -------- TX (FT232)
(ESP) TX -------- RX (FT232)
(ESP) GND ------- GND (FT232)
(ESP) VCC ------- VCC 3.3V (FT232)
(ESP) EN -------- VCC 3.3V (FT232)
(ESP) GPIO0 ----- VCC 3.3V (FT232)

Try 3:
(ESP) RX -------- TX (FT232)
(ESP) TX -------- RX (FT232)
(ESP) GND ------- GND (FT232)
(ESP) VCC ------- VCC 3.3V (FT232)
(ESP) GPIO0 ----- VCC 3.3V (FT232)

But everytime sketch does not start after upload. This is not a code problem, because I try start "blink" sketch or other. Everytime ESP work once, after upload.

2

2 Answers 2

1

Thank you gre_gor. You were right about correct pins. If you want start ESP on "normal mode" you must plug pins like:

(ESP) GND ------- GND
(ESP) GPIO15 ---- GND
(ESP) VCC ------- VCC 3.3V
(ESP) EN -------- VCC 3.3V
(ESP) GPIO0 ----- VCC 3.3V
(ESP) GPIO2 ----- VCC 3.3V

But if we must use GPIO0, GPIO2 and GPIO15 how we have 9 GPIO, 2 UART and 1 ADC?

0

For me the same issue happened once ,i tries flashing the AT commands firmware (can download from espressif website)and then burned my test firmware to it ...worked.Try it..!

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.