I am using the Leonardo board with the Adafruit Motor Shield v2, 2 steppers and the Yun Shield. The yun shield and steppers all run harmoniously, however, as soon as I do Bridge.begin() and anything that accesses the Yun shield Bridge library to access the console, the steppers stop running. Is this to be expected and are there any solutions?


1 Answer 1


Looking at Bridge.begin() description here you can see this is blocking function.

begin() is a blocking function. Once you call Bridge.begin(), nothing else will happen in your sketch until it has completed. This process takes approximately three seconds.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.