2

I use ESP8266-12 with an Arduino Uno as a USB-serial adapter.

When I upload any sketch to the ESP8266 it works fine until I reset the ESP8266.

uint32_t realSize = ESP.getFlashChipRealSize();
uint32_t ideSize = ESP.getFlashChipSize();
FlashMode_t ideMode = ESP.getFlashChipMode();

Serial.printf("Flash real id:   %08X\n", ESP.getFlashChipId());
Serial.printf("Flash real size: %u\n\n", realSize);

Serial.printf("Flash ide  size: %u\n", ideSize);
Serial.printf("Flash ide speed: %u\n", ESP.getFlashChipSpeed());
Serial.printf("Flash ide mode:  %s\n", (ideMode == FM_QIO ? "QIO" : ideMode == FM_QOUT ? "QOUT" : ideMode == FM_DIO ? "DIO" : ideMode == FM_DOUT ? "DOUT" : "UNKNOWN"));

if(ideSize != realSize) {
    Serial.println("Flash Chip configuration wrong!\n");
} else {
    Serial.println("Flash Chip configuration ok.\n");
}

delay(5000);

If I ground reset button, garbage values are being shown.

Connections details:

EN - 3.3V of Uno
VCC - 3.3V of Uno
RST - GND Of Uno(If needed)
TX - TX of Uno
RX - RX of Uno
GPO15 - GND of Uno
GPO01 - GND of Uno
GND - GND of Uno

closed as unclear what you're asking by per1234, user31481, Greenonline, MatsK, jose can u c Nov 9 '17 at 20:34

Please clarify your specific problem or add additional details to highlight exactly what you need. As it's currently written, it’s hard to tell exactly what you're asking. See the How to Ask page for help clarifying this question. If this question can be reworded to fit the rules in the help center, please edit the question.

  • 1
    Possible duplicate of ESP8266 + Arduino Uno: Can't send AT Commands – gone Aug 16 '17 at 13:56
  • 2
    Please edit your question to include a Minimal, Complete, and Verifiable example of code, not just snippets. – user31481 Nov 4 '17 at 10:28
0

Espressif says it can not be disabled.

Ref.: https://github.com/esp8266/Arduino/issues/3047

Not the answer you're looking for? Browse other questions tagged or ask your own question.