0

I am using atmega328p in my PCB prototype, due to some reason I can use only 4 volt for power supply. My question is that "How to run atmega328P through 4 voltage"

Improve this question
2
  • 4
    Have you read the datasheet?
    – Milliways
    Apr 15, 2017 at 8:00
  • 2
    Your question is rather fuzzy: I could well answer it as "Connect the +4V to Vcc pin and 0V to the GND pin", that would be correct. What is your specific question?
    – jfpoilpret
    Apr 15, 2017 at 9:45

2 Answers 2

Reset to default
3

Shouldn't be a problem. The minimal voltage required to run at 16MHz is 3.8 Volt. No extra steps required.

Improve this answer
0

Having only a 4V power supply, you can insert a boost converter to step up the voltage to 5V and then supply it to VCC of atmega328p

Improve this answer

Not the answer you're looking for? Browse other questions tagged or ask your own question.