0

I am trying to set up an LCD screen without using a resistor or a potentiometer for an Arduino project. This is the LCD I am using: Basic 20x4 Character LCD.

But when I connect to +5V on the Arduino board, my Arduino board turns off. This is how I have the LCD connected to the Arduino on a breadboard.

enter image description here

Connections:

LCD RS pin to digital pin 12

LCD Enable pin to digital pin 11

Data:

• LCD D4 pin to digital pin 5

• LCD D5 pin to digital pin 4

• LCD D6 pin to digital pin 3

• LCD D7 pin to digital pin 2

LCD R/W pin to ground

LCD VSS pin to ground

LCD Cathode pin to ground

LCD Anode pin to digital pin 9

LCD VCC pin to 5V

Code:

// include the library code:
include <LiquidCrystal.h>
// initialize the library with the numbers of the interface pins
LiquidCrystal lcd(12, 11, 5, 4, 3, 2);

void setup() {
  analogWrite(6,20);
  // set up the LCD's number of columns and rows:
  lcd.begin(20, 4);
  // Print a message to the LCD.
  lcd.print("hello, world!");
}

void loop() {
  // set the cursor to column 0, line 1
  // (note: line 1 is the second row, since counting begins with 0):
  lcd.setCursor(0, 1);
  // print the number of seconds since reset:
  lcd.print(millis() / 1000);
}
  • Anode pin always connects with 5V... See my answer diagram. It will helpful. – Hasan Mar 31 '17 at 6:34
4

Try out this connection. It will helpful.

LCD Connection

0

Looking at your picture, it seems that you're powering everything through a USB cable. USB 1.x and 2.0 can supply up to to 500 mA AFTER the port is enumerated, otherwise the current is limited to 100 mA.

A quick current consumption budget:

  • LED backlight of your LCD module: typ 240 mA
  • Arduino Mega2560: min 70 mA
  • MIDI shield: some 15-35 mA

That's just 325-350 mA to begin with, and probably higher than that. It's still safely within the 500 mA limit, but as I said some computers will provide 500 mA only after successful enumeration of the device connected to the USB port.

My recommendation for you would be to power your Arduino + MIDI shield + LCD through a wall adapter > 7V. If it works, then the problem is your USB port being unable to supply the required current right from the start.

  • Alright ill try that out. it my not be visible but i also have an Mp3 shield between the Midi shield and arduino – Hjhk90 Mar 31 '17 at 19:08
  • Well, that will add some current consumption as well. You might be already above 500 mA! Under that load, the USB port of the computer shuts himself off for protection. – Enric Blanco Mar 31 '17 at 19:11
  • i think i found the issue one of the pins on the LCD might have been causing a short when i connected to 5v pin .i fixed it and it seems to be working. i did this with the shields on the arduino removed. i will add them back on and see if it works. if it dose not i know the issue is related to the power consumption of the USB. thanks for your help – Hjhk90 Mar 31 '17 at 21:42

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.