I have a sketch to display a temperature obtained from 1-wire DS18B20 sensors. The sketch works fine, however when I connect two sensors to my board, the text on the LCD displays gets corrupted (### and other symbols shown instead of a temperature).
I have tried plugging each of the two DS18B20 sensors individually and it works with both of them, the problem shows only when I use both at the same time. I am connecting them both with black to ground, red to 5V and white to Dx and to 5V via a 4.7 kOhm pull-up resistor.
I have little idea how to check what is wrong - is it some kind of interference, insufficient voltage, or a SW problem?