I'm trying to connect a FLIR Lepton to an Arduino Due. A thread by pureengineering talks of rerouting some pins. I am not sure what they precisely mean.
Does this rerouting mentioned in the link also apply to Arduino Due?
Arduino Stack Exchange is a question and answer site for developers of open-source hardware and software that is compatible with Arduino. It only takes a minute to sign up.Sign up to join this community
According to the highlighted part of
Due schematics it'd be better to connect
3.3V to the
AREF pin as there might be some significantly big resistor between
3.3V source. So it might not be needed but one never knows.
Edit: Looking at the DUE board, there is "jumper" resistor, so you can choose 3V3 or AREF, that means AREF is not connected to anything by default. So if you connect 3v3 to AREF, it should be fine (even 5V, if you didn't changed anything on board yet )