-1

If I don't declare Serial.begin(115200), I can send AT commands over serial monitor and it replies me.

But when I declare Serial.begin(115200) and send AT commands inside program or serial monitor there is nothing happens.

Did I miss something?

  • 1
    Just copy-paste the code/output. Don't post screenshots. – gre_gor Feb 9 '17 at 13:59
  • But I'm not answer to someone. You don't need the codes. – ozgrozer Feb 9 '17 at 15:13
2

You have connected the tx of the Arduino to the tx of the ESP8266 and the rx of the Arduino to the rx of the ESP8266.

What is happening when you type AT in the Serial Monitor is that you are communicating directly with the ESP8266, and not with the Arduino.

You need to connect the rx of the Arduino to the tx of the ESP8266 and the tx of the Arduino to the rx of the ESP8266.

This has asked and answered a number of times, such as:

Arduino Uno and ESP8266 serial monitor issue

Arduino & ESP8266

Arduino Nano v3.0 with ESP8266

ESP 8266 does not respond at all

Your ESP8266 definitely uses a baud rate of 115200 (as confirmed by your first screen shot), so you don't need to change that when experimenting.

| improve this answer | |
0

Thank you for the answer @Holmez, third link was very helpful. I was just change the code and the RX, TX pins like below and it works perfect now. I can send commands to the ESP both in program and over the serial monitor.

#include <SoftwareSerial.h>

SoftwareSerial wifi(10, 11);

void setup() {
  Serial.begin(115200);
  wifi.begin(115200);
  Serial.println("Test");
  wifi.println("AT+CIFSR");
}

void loop() {
  if (Serial.available()) {
    wifi.write(Serial.read());
  }
  if (wifi.available()) {
    Serial.write(wifi.read());
  }
}
| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.