0

Our project involves using an arduino compatible microcontroller to control a mouse on a computer with an accelerometer and flex sensor. We had narrowed down to the ATTiny85 due to its small size.

We found a particular tutorial on the Adafruit tutorial website, using the Adafruit Pro Trinket using the same ATTiny85.

Is there a reason to believe that this won't work?

Also, does anyone have suggestions as to which board to use apart from Micro as it isn't too available here?

closed as primarily opinion-based by Mattia, jfpoilpret, KIIV, Avamander Dec 4 '16 at 20:32

Many good questions generate some degree of opinion based on expert experience, but answers to this question will tend to be almost entirely based on opinions, rather than facts, references, or specific expertise. If this question can be reworded to fit the rules in the help center, please edit the question.

2

Due to the lack of USB-Support of the ATtiny85 you will be forced to use something like V-USB as the tutorial does. This might have implications when you are targeting a commercial product.

Personally I'd suggest using the ATmega32u4. It has USB build right in.

But basically I don't see any reasons why it should not work.

  • If we use a breakout board with a USB like – Souvik Saha Nov 22 '16 at 16:58
  • If we use a breakout board with a USB like this one we won't need V-USB right? amazon.in/dp/B00Z09R3YC/ref=cm_sw_r_cp_apa_i_LKhnyb5J9FFWE – Souvik Saha Nov 22 '16 at 17:01
  • The description tells so. But it does not state how the USB is addressed. I suspect there is a boot loader that is used for programming (and therefore reduces the available space) basing on V-USB or similar. Perhaps it provides a wrapper so you can address USB easily. – Kwasmich Nov 22 '16 at 17:30
  • There is a USB port right? – Souvik Saha Nov 23 '16 at 3:21
0

@Kwasmich raises a good point about the 32u4. Here is a little more information about it.

  • Works at 5V and 3.3V
  • Compatible with the Arduino IDE
  • Built-in USB
  • Very close to the ATmega328

Here are a couple of cheap breakouts for it

  • You forgot about the Arduino Leonardo – Kwasmich Nov 22 '16 at 13:27
  • @Kwasmich, too big, never seen a mouse that big. I suggested the smallest models. – Dat Ha Nov 22 '16 at 13:44
  • @Kwasmich we were aiming to be as portable as possible. – Souvik Saha Nov 22 '16 at 16:52

Not the answer you're looking for? Browse other questions tagged or ask your own question.