2

first of all, I'm kindly apologizing for asking such stupid questions, but as my electronic-knowledge is dramatically limited, you are my only hope to get my problem solved.

I'm pretty new to Arduino and my plans are to stack a lcd shield on a motor shield, which is stacked on the Arduino.

My setup would be the following:

My target is to enter specific values trough the LCD-shield (with its buttons) and to control a stepper-motor related to those.

Now to my question: Can I realize my project with the mentioned parts and are the two shields stackable (with head extentions on the motor-shield) without creating interferences?

Thank you very much for your time and answers in advance.

Best regards,

irie

4

No, it doesn't look like it.

The LCD board uses digital pins 4-10 and analog 0

The motor board uses digital pins 3-12 if all motors are used.

If you need to stack boards look for boards that use I2C since they can share a single data bus.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.