I am using CS5211AGP wireless RF transmitter to transmit some data and another side receive this data through nRf905 as receiver. But now problem is how can I decode RF transmitter address (because transmitter and receiver address must be same).

if any one working on this module then please suggest me how can I decode address.

Please show below image where you can see the connection of address and zone.enter image description here

enter image description here

Now please say about what address should I set at receiver side for communication.

Thanks in advance.

Regards, rajneesh

  • I don't think the nRf905 and CS5211AGP are compatible. They both use their own protocol.
    – Gerben
    Sep 3 '16 at 15:19

I am looking at mine, wich address is 01212012, acording to a sticker in a side. I can see in mine jumpers as follows (starting from A0): -HLHL-HL-H-H where - means no jumper. Based on my sticker I can see that 0 is equivalent to NO-JUMPER, 1 is H and 2 is L. By watching yours I can tell that your code is 21111002. The other 4 jumpers is what I don-t understand, but if I change any of them, my alarm no longer detects any change. Hope this helps... Regards.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.