0

I have the setup described here: https://learn.adafruit.com/esp8266-temperature-slash-humidity-webserver/wiring

I currently have the reset pin set to float and the GPIO0 pin grounded, which should make it execute the uploaded program, but instead I get the flash mode output:

    writing flash
...................................................................................................................................................................................................................................................

How do I put it into execution mode?

Improve this question
3
  • Try putting a pullup on Reset and GPIO0.
    – JRobert
    Commented Aug 2, 2016 at 21:52
  • GPIO0 pin grounded, which should make it execute - no, GPIO0 grounded is how to put the thing into programming mode
    – Jaromanda X
    Commented Aug 5, 2016 at 12:14
  • What is the correct configuration then?
    – pulsar100
    Commented Aug 5, 2016 at 19:44

1 Answer 1

Reset to default
1

I was stuck in a similar scenario. I managed to exit programming mode by floating GIPO0, then grounding RST for ~3 seconds, then floating it. If you power off the esp, and now turn it on, it should have exited programming mode. Powering it off is actually optional.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.