-1

My wire schema ;

http://bloglug.com/wp-content/uploads/2015/08/Arduino-esp8266-baglantilari.png

And i'm using arduino, it has blank loop. I'm trying AT command by using Serial Monitor and I have no response..

  • what do you mean by "blank loop"? – JayEye May 7 '16 at 23:24
  • I mean ; void loop { } – faksu3442 May 7 '16 at 23:36
  • OK, where is your PC connected in all of this? – JayEye May 8 '16 at 1:18
0

These tutorials often forget to tell you to place the ATmega chip in RESET if you want it to function as a UART-USB-pass-through. This is easily done by connecting the RESET pin to GND with a jumper. Also consider powering the ESP from a more powerful source, like the Arduino 5V pin through an LM1117 regulator. Don't forget to set your Serial Monitor to Both NL & CR. Use a voltage divider between the Arduino's RX pin and that of the ESP, to reduce the 5V signals to 3.3V.

| improve this answer | |
  • I am using external power source too but it dont works. So i will try voltage divider between rx pins – faksu3442 May 8 '16 at 10:23
  • @faksu3442 more importantly, did you connect the RESET pin to GND? – SoreDakeNoKoto May 8 '16 at 11:50
  • Oh forgive me, no i did not it and when i go my home i will try it too. As you say, any tutorial do not say this pin. I will post the results here – faksu3442 May 8 '16 at 11:53
  • I have connect RESET pin to GND but there is no response still. – faksu3442 May 8 '16 at 19:32
  • @faksu3442 did you use the voltage divider? It is very easy to damage your ESP by using 5V signals instead of 3.3V. Have u set the Serial monitor like I said? – SoreDakeNoKoto May 8 '16 at 19:37

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.