I am trying the esp8266 esp-01, and did all it asked on the arduino IDE side, but i am having problems compiling and building the blink example into the board
Using: FT232RL usb-ttl in the 3.3v configuration, two 1.6v (new) batteries to power the esp, and all the conections as indicated here (not using the led though).
when I hit (go) it compiles, but as it transfers both boards blink sincronously and I recive the following errors:
O sketch usa 219.479 bytes (50%) de espaço de armazenamento para programas. O máximo são 434.160 bytes. Variáveis globais usam 31.172 bytes (38%) de memória dinâmica, deixando 50.748 bytes para variáveis locais. O máximo são 81.920 bytes.
error: failed reading byte warning: espcomm_send_command: cant receive slip payload data error: failed reading byte warning: espcomm_send_command: cant receive slip payload data error: failed reading byte warning: espcomm_send_command: cant receive slip payload data error: failed reading byte warning: espcomm_send_command: cant receive slip payload data error: failed reading byte warning: espcomm_send_command: cant receive slip payload data error: failed reading byte warning: espcomm_send_command: cant receive slip payload data error: failed reading byte warning: espcomm_send_command: cant receive slip payload data error: failed reading byte warning: espcomm_send_command: cant receive slip payload data error: failed reading byte warning: espcomm_send_command: cant receive slip payload data warning: espcomm_sync failed error: espcomm_open failed error: espcomm_upload_mem failed
I looks to me as a newbie that its trying to establish a link and failing... what could it be?
the configurations are default, programmer is "AVRISP MKII"