0

I bought a few PFC8574 and 4x4 keypads for a small project. I'm unclear on the correct wiring of the keypad to the PFC8574.

On the Arduino Playground's site, there are pull-up resistors for each column, but on a few other sites (like this one that I can't read, but I understand a schematic and there's a third example too, but I don't have the reputation to post it), the wiring does straight into the IC.

Does it depend on the library that's being used? Or what am I missing?

Thanks!

1

Ok look at this image: enter image description here

I'm not sure how your keypad is layed out but if you use a probe pin to test your connections via a multimeter, you can mark which ones correspond to the image.

I am ASSUMING you are going to use the code from arduino playground.

This is the format:

Pins of keypad (IN THE IMAGE) - Pins of PFC8547

Here are the pin connections:

1 - nothing

2 - 9

3 - 4

4 - 6

5 - 7

6 - 10

7 - 11

8 - 5

Also include the pull-up resistors. Your ABCD keys will be ignored

(This is like wiring a bomb...)

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.