0

I just purchased this Grove RTC. It includes a cable presumably to connect it to a breadboard and/or Arduino, but the pin holes on this cable are much smaller than those on a breadboard or Arduino.

How/where would I connect this in the case of using an Arduino Uno?

enter image description here

2
  • 2
    If you want a quick temporary solution, you can probably stick 22 gauge wires in that connector, secure with electrical tape and put the other end in your breadboard. Commented Mar 19, 2016 at 21:04
  • 1
    I would get two jumper wires (with a male plug at each end) chop them into half so you now have four wires, each with a bare end and a plug, strip the wire where it was cut, and solder the 4 bare wires to your socket, and then plug the plugs into the breadboard.
    – Nick Gammon
    Commented Mar 19, 2016 at 21:39

1 Answer 1

0

Either use jumper wire, or pull the connectors from the Housing and connect them with male connectors.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.