Is there Arduino shields with blocks of 4 pins that you can plug your servos into and use the fourth pin as signal pin to the Arduino Mega board?

  • You could (probably) easily make this yourself (using an Arduino prototype board and some pin-headers) or buy an arduino "servo controller shield". Also, Arduino.Stack Exchange isn't the place for shopping recommendations, you could ask suppliers/manufacturers if they have such a thing available. It's also a little unclear, do you want the 3 servo's to receive the same signal? You could simply attach them to the same header and "short", solder or jumper the pins together. – Paul Mar 17 '16 at 10:04

Do you mean something like a sensor shield? They have three pins (Vcc, GND, signal), not four (because servos have three pins), but they are designed for connecting a large number of servos Arduino Mega sensor shield

These can be found easily and cheaply all over the internet.

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.