Just a quick question. Picking up some stepper motors, but confused at what voltage/current things are running off.
An article says
You need some 12V source to the EasyDriver (the motor in this article is 12V) - This will be powering the stepper - Im using a 12V adapter - similar to the one in the illustration. Just make sure it is rated at least 750ma - A higher rating is better, and just means it wont burn out.
So does that mean if I got a plug which is regulated 12V 1A and powered the Arduino from that I could power a rail with VIN pin and that would safely supply the EasyDrivers? And I could then use the 5V pin to power everything else?
Just don't want to break anything! Thanks