1

I just got a Mux Shield 2 and got it working as I expected. Now I started to find out how to actually connect the I/O cables to the board. Doesn't seem to be as simple as I thought. I don't want to solder cables into the board for maintenance reasons. So, does anyone have any good tips on how to do this?

Photo of shield

migrated from electronics.stackexchange.com Jul 28 '15 at 20:51

This question came from our site for electronics and electrical engineering professionals, students, and enthusiasts.

  • if you want plugs, solder plugs onto it. – PlasmaHH Jul 28 '15 at 8:52
1

Solder 100-mil male headers onto the board, then use 100-mil crimp terminals to connect the wires.

100-mil male headers Female crimp terminals Connected

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy