I recently purchased Bluno Beetle (basically a smaller Arduino with a BLE chip). It is based on the Bluno: Wiki I know that its Bluetooth Chip, the TI CC2540, supports the Broadcast mode: Official page

However I can't find any AT commands that would allow me to set it to this mode, does anyone of you have an idea? I am trying to relay the messages they are sending (sensor readings), essentially building an interconnected network.


It looks like the Bluno only supports the Central and Peripheral roles (i.e. not the Broadcaster and Observer roles.) Keep in mind AT commands are a feature of the firmware, not the actual chip. As such, even if the chip supports a particular mode or role, that doesn't necessarily mean the firmware makes the feature available.

  • That's what I was afraid of :-/ Thanks for your answer though!
    – Rudolf
    Jul 22 '15 at 19:26

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.