5

I am using Arduino Yun and I would like to disable it to work as Access Point. That is, I don't want that it is displayed in the list of available networks.

Then I would like to set and use it (separately) in the following scenarios:

a) Arduino Yun connected just over a given Wi-Fi network (Ethernet connection disabled).

b) Arduino Yun connected just over Ethernet (Wi-Fi connection disabled).

How can I make it?

Note: In my previous attempts I tried to customize and/or disable someway the Wi-Fi connection (through the LuCI panel) in order to reach what I am looking for but in all of these cases I had to restore my Arduino Yun from scratch because it did not work anymore.

2

Yun expects wifi to be working and, if it's not, it will reboot itself after 60 seconds and return in access point mode.

In order to disable this check, edit file /etc/rc.local and turn wifi-live-or-reset into #wifi-live-or-reset (with a starting #).

Once done, use LuCI (the advanced configuration panel) to configure network interfaces.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.