I am looking to devise a level tracking system using arduino and some sensors. My particular situation is I have solute that is coming out of solution and I want to track the formation rate of the solid phase as the salts settle at the bottom and build a bed of particulates.

I am looking for precision at about 0.5mm and over a range of like 6 inches. My initial idea was to get a sensor bar that could detect when and where light is hitting the sensor and post processes that signal. I have to design this device to sit outside the cylindrical vessel. The solvent is transparent so any form of light would work. I am stuck on finding the parts that could pull this off and I was hoping the more experienced community could point in the right direction.


a little cartoon for a clearer picture of the idea I am leaning towards capacitance since using light seems like a rabbit hole. I was playing with some foil and it may work but I need a much more sensitive tool on the order of pico-Farads to work.

enter image description here

  • What is the distance between the sensors? If it's a short distance, you could possibly get away with using two clear tubes and putting sensors in one tube and then lights in another tube. Apr 27 '15 at 21:36
  • @AnnonomusPenguin The diameter of the tube that contains the liquid I want to measures is on the order of 3cm. My best thought thus far was to go for an approach parallel plate capacitors, but I am not sure that would work to well. I need really high resolution since the materials would have low k values. Apr 29 '15 at 14:22
  • Ultrasonic sensor?
    – RSM
    Apr 29 '15 at 16:11
  • @RSM how would that work? I am thinking I need to account for possibly 6 inches in elevation change. Apr 29 '15 at 16:48
  • @TheCodeNovice the time from the transmit to the time of receive would change as the level increases. If the liquid level increase with proportionally to the increase of the solid the level sensor could work. Also there capacitive sensors for level sensing, partially described here en.m.wikipedia.org/wiki/Level_sensor
    – RSM
    Apr 29 '15 at 18:50

What about measuring this with two resistive probes - the electricity will go through down one probe to the top of the water, across the water, and up the other probe. You can measure how much of the probe it went down, by measuring the resistance. You would need the probes to be a specific, very consistent distance apart, and be made of resistance wire.

Another option is to use a float of some kind, and measure it this way. This is a lot easier if all you need to know is full/not full.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.