I am trying, unsuccessfully to communicate, using my Arduino Nano, with a custom device at a baud rate of 800 kbit/s.
The Arduino code look like this:
void setup() {
// Put your setup code here, to run once:
Serial.begin(800000);
}
void loop() {
// Put your main code here, to run repeatedly:
delay(5000);
Serial.println(0x2be1);
}
When I am trying to debug it with PuTTY the result is:
And when I change the baud rate to 400 kbit/s the result is (as it should be):
Any idea?