What are the Ramps pins on my Arduino mega?

Question

I've been working on a 3D printer and I've come to the last step, which is wiring it all up.

The 3D printer I'm making works ONLY with the Arduino Mega. No Ramps. If I need to get Ramps later, I will, but for now, can someone please help me understand which of the Ramps pin goes with which Arduino pin. For example, in the Repetier firmware, the code is like this:

#define X_STEP_PIN         54
#define X_DIR_PIN          55
#define X_ENABLE_PIN       38
#define X_MIN_PIN           3
#define X_MAX_PIN           2

But Arduino doesn't have a 54 and a 55 pin. I've been googling this and I found that Ramps pins 54 - 69 are the same as pins A0 - A15 on the Arduino Mega.

I know this but not for the other pins...

Can someone please tell me the connection of all the Ramps pins to the Arduino pins?

Like: pin 54 on Ramps = A0 on Arduino. I need this for all of the pins.

Answer 1

You are right, your have all the information in your question.

Pin 54 Refers to the Arduino PIN Number, nothing to do with RAMPS. 0-53 are the digital pins and the 54 is A0, etc. So the pin numbers should go higher than 69, which is A15.

Answer 2

You're very close to your answer. Here are the specifics:

Name      software pin  Mega2560 board label
X_STEP_PIN    54         Analog A0
X_DIR_PIN     55         Analog A1
X_ENABLE_PIN  38         Digital 38
X_MIN_PIN     3          PWM 3
X_MAX_PIN     2          PWM 2

http://reprap.org/mediawiki/images/3/3f/Arduinomegapololushieldschematic.png shows the mapping.