Skip to main content
10 events
when toggle format what by license comment
May 12, 2020 at 0:32 vote accept Anders Kitson
May 8, 2020 at 1:28 answer added hcheung timeline score: 1
May 8, 2020 at 0:54 comment added Anders Kitson I added my new config above still no luck
May 8, 2020 at 0:53 history edited Anders Kitson CC BY-SA 4.0
added new config
May 8, 2020 at 0:49 comment added Anders Kitson that's a mistake on my part I was using 10k, but the 330 I guess was in the wrong spot, so I moved it to the backlight pin, now It doesn't light up. Have to figure this out now.
May 7, 2020 at 23:46 comment added SoreDakeNoKoto Follow the instructions on your page: use 10k (not 10 ohms) on the signal lines. Get rid of the 330-ohm connected to the display's VCC, there should no resistance there at all. Use that 330-ohm for the BL pin instead.
May 7, 2020 at 20:20 comment added Anders Kitson I don't see any errors, I can console log the board, and the repl just starts with johnny five
May 7, 2020 at 20:03 review First posts
May 8, 2020 at 14:15
May 7, 2020 at 20:00 comment added jsotola does the code compile without errors?
May 7, 2020 at 19:56 history asked Anders Kitson CC BY-SA 4.0