Skip to main content
added required stty speed setting - after running through this I realized it is needed.
Source Link
Adam F
  • 111
  • 3

The Arduino CLI uses a slightly different version of bossa from the one that is on master:

https://github.com/shumatech/BOSSA/tree/arduino

On Linux, I was able to do the following:

$ git clone [email protected]:shumatech/BOSSA.git
$ cd BOSSA
$ make bin/bossac -j4
$ stty -F /dev/ttyACM0 1200
$ ./bin/bossac --port=/dev/ttyACM0 --force_usb_port=true -e -w -v -b /path/to/my/firmware.bin -R

(I got the answer from this Arduino forum thread.)

The Arduino CLI uses a slightly different version of bossa from the one that is on master:

https://github.com/shumatech/BOSSA/tree/arduino

On Linux, I was able to do the following:

$ git clone [email protected]:shumatech/BOSSA.git
$ cd BOSSA
$ make bin/bossac -j4
$ ./bin/bossac --port=/dev/ttyACM0 --force_usb_port=true -e -w -v -b /path/to/my/firmware.bin -R

(I got the answer from this Arduino forum thread.)

The Arduino CLI uses a slightly different version of bossa from the one that is on master:

https://github.com/shumatech/BOSSA/tree/arduino

On Linux, I was able to do the following:

$ git clone [email protected]:shumatech/BOSSA.git
$ cd BOSSA
$ make bin/bossac -j4
$ stty -F /dev/ttyACM0 1200
$ ./bin/bossac --port=/dev/ttyACM0 --force_usb_port=true -e -w -v -b /path/to/my/firmware.bin -R

(I got the answer from this Arduino forum thread.)

Source Link
Adam F
  • 111
  • 3

The Arduino CLI uses a slightly different version of bossa from the one that is on master:

https://github.com/shumatech/BOSSA/tree/arduino

On Linux, I was able to do the following:

$ git clone [email protected]:shumatech/BOSSA.git
$ cd BOSSA
$ make bin/bossac -j4
$ ./bin/bossac --port=/dev/ttyACM0 --force_usb_port=true -e -w -v -b /path/to/my/firmware.bin -R

(I got the answer from this Arduino forum thread.)