1

i'm having few PCF8574P which i want to use with my arduino and multiplex them however i have no idea how to use the I2C BUS and the IC in general. There are few libraries but they're fairly complex. Is there any library which makes writing and reading from the PCF8574P easy?

1 Answer 1

2

Have you given Rob Tillaart's library from the Arduino Playground a try? The demo sketch might look a bit overwhelming, but at it's simplest, all your sketch should need to have to make a led blink like the standard arduino 'blink' sketch is

#include "PCF8574.h"
#include <Wire.h>

// adjust addresses if needed
PCF8574 PCF_38(0x38);  // add led to P0 (pin 4) (used as output)

void setup()
{
//your setup code here
}

void loop()
{
    //turn P0 (pin 4) of the I/O expander on and off once a second
    PCF_38.write(0, 1);
    delay(1000);
    PCF_38.write(0, 0);
    delay(1000);
}

I don't have any of these parts handy so I can only give generic advice.

1
  • This is good..simple code to blink one led. It works..I like it. Cheers...Markus
    – Markus
    Oct 1, 2017 at 8:35

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.